Standard operating procedures for standardized mass rearing of the dengue and chikungunya vectors Aedes aegypti and Aedes albopictus (Diptera: Culicidae) - I - egg quantification

Background Quantification of eggs prior to rearing the immature stages of mosquitoes is an essential step in establishing a standardized mass rearing system. To develop a simple and accurate method of egg quantification for Aedes aegypti and Aedes albopictus, the relationship between egg number and weight, as well as egg number and volume, were studied. Methods Known quantities of eggs (1,000, 3,000, 6,000, 12,000, 15,000, 18,000, 21,000 and 27,000) were counted and subsequently their weight and volume were measured. Best-fit curves and regression equations were used to describe relationships between Aedes egg number and both weight and volume. Results Eighteen thousand Ae. aegypti eggs weighed 159.8 mg and had a volume of 277.4 μl, compared to measurements of 131.5 mg and 230.3 μl for Ae. albopictus. The eggs of Ae. aegypti were thus larger and heavier than those of Ae. albopictus. The use of weight and volume to quantify egg number was validated by counting volumes and weights of eggs expected to correspond to 3,000 and 18,000 eggs of each species; significant correlations were found in all cases except in the case of 3,000 Ae. albopictus eggs measured by volume. Conclusion Methods for egg quantification were validated and shown to be a consistent and practical means to achieve uniform distribution of Aedes larvae between rearing trays, important for optimal mass rearing of the immature stages of Aedes mosquitoes.


Background
The incidence of dengue has grown dramatically around the world in recent decades with over 3 billion people now at risk [1]; the disease is endemic in more than 100 countries in Africa, the Americas, the Eastern Mediterranean, Southeast Asia and the Western Pacific and outbreaks are becoming more frequent. While Aedes aegypti remains the primary vector of the dengue virus, Ae. albopictus is playing an increasingly important role.
One strategy being pursued to more effectively control these disease vectors Area-Wide Integrated Vector Man-agement (AW-IVM) programmes with a sterile insect technique (SIT) component, which has succeeded in controlling other insect pests of agricultural significance such as fruit flies, tsetse flies, and the New World screwworm [2][3][4][5][6]. Since 2010, the Insect Pest Control Laboratory (IPCL) of the Joint FAO/IAEA Division of Nuclear Techniques in Food and Agriculture, Seibersdorf (Austria) is developing an SIT package for Aedes mosquitoes which includes techniques and equipment for mass-rearing, sex separation, and sterilization. A larval rearing unit comprising a rack containing 50 trays [7], high efficiency diet formulations for larval development [8,9] and an adult mass-rearing cage [10] have also been developed for Ae. albopictus and are being tested for Ae. aegypti.
Development of mass-rearing tools and standard operating procedures (SOPs) are not only useful for the classical SIT using radiation to sterilize the males, it is also a prerequisite for the Incompatible Insect Technique (IIT) using Wolbachia-infected males [11,12] and for transgenic population suppression approaches such as RIDL [13,14]. All techniques mentioned above require the production of large numbers of high quality males for sequential releases into the target area to induce sterility into the wild mosquito population. In order to achieve this goal, standardization of all steps of the mass-rearing process is required, starting from egg production. Each tray of the rack/tray system needs to be seeded with the same number of eggs to control and ensure the quality of the final product, avoiding disparities between trays. An accurate quantitative estimation of eggs would allow a consistent distribution of eggs, avoiding underfilling or overcrowding. Underfilling leads to production inefficiency, a waste of rearing diet and potential overfeeding while overcrowding leads to small pupae and adults, prolonged development times and increased mortality [15,16].
In the present paper, we propose two standardized methods for estimation of egg numbers for Ae. aegypti and Ae. albopictus, based on weight or volume, that could be used for routine rearing or mass-rearing purposes.

Ethics statement
The blood used for routine blood-feeding was collected in Vienna, Austria during routine slaughtering of pigs or bovines in a national authorized abattoir at the highest possible standards strictly following EU laws and regulations.

Colony maintaining for experiments
Ae. aegypti and Ae. albopictus laboratory colonies originating from Juazeiro, Brazil and Rimini, Italy, respectively, were used for all experiments. Larvae were reared in plastic trays (30 × 40 × 8 cm) containing 1 liter of deionized water held at a constant air temperature of 27 ± 1°C and a photoperiod of 12:12 (L:D). Larval food comprised 50% tuna meal, 36% bovine liver powder, 14% brewer's yeast and 0.2 g of Vitamin Mix per 100 ml of diet solution. approximately 4-5,000 adult mosquitoes were reared per 60 × 60 × 60 cm cage (Bioquip, Rancho Dominguez, Ca.) at a constant ambient temperature of 25 ± 1°C, a photoperiod of 12:12(L:D)and relative humidity of ca. 70%. Blood meals were offered to females three times per week and a 10% sugar solution was constantly available.

Egg collection, drying and storage
Females were allowed to oviposit in a cylindrical container (diameter 11.4 cm, height 9.7 cm, BioQuip, Rancho Dominguez, Ca.) containing deionized water and lined with crêpe paper (Sartorius Stedim Biotech GmbH, Göttingen, Germany). Egg-papers were removed and gently washed with deionized water using a plastic washing bottle to remove dead adults and transferred into a covered larval rearing tray for gradual drying over 24-48 hours at 27 ± 1°C and 70% RH. Egg-papers were transferred into plastic zip lock bags and kept in a sealed black plastic box for maturation in the larval rearing room, at conditions described above. All eggs used in these experiments were collected, stored and treated in the same way, all no older than 15 days post-oviposition.

Relationship between quantity and weight of eggs
Eggs were brushed from their papers using a small paint brush and collected on a ceramic palette for counting under a stereomicroscope. Batches of 1,000, 3,000, 6,000, 12,000, 15,000, 18,000, 21,000 and 27,000 eggs were transferred into 1.5 ml Eppendorf tubes for weighing using an electronic balance with an accuracy of 0.0001 g. Each size of egg batch was repeated at least 3 times for each species, using different batches of eggs each time.   (5) 10.61 *** "N" is the number of replicates; "***" represents P < 0.001.

Relationship between quantity and volume of eggs
Using the protocol described above, we measured the volume occupied by the different numbers of eggs (1,000, 3,000, 6,000, 12,000, 15,000, 18,000, 21,000 and 27,000 eggs) in Eppendorf tubes. Eggs were removed and the tubes filled with deionized water to the same level and weighed. Volumes were calculated from the density of water: 1 mg of deionized water has a volume of 1 ml, as confirmed in a prior test (data not shown). Measurements of each egg quantity were repeated at least 3 times.

Validation of the relationship between egg number and weight
To validate the relationship between egg number and weight, 3,000 and 18,000 eggs were weighed out based on the mean weights of eggs estimated in the previous experiment (Table 1), then counted to compare actual with expected numbers. Validation counts were made for 3,000 and 18,00 eggs at least three times each, for each species.

Validation of the relationship between egg number and volume
Deionized water was added to Eppendorf tubes in quantities corresponding to the volumes measured as described above for 3,000 and 18,000 eggs (Table 2), and the volume marked on the tubes. Eggs were added to the Eppendorf tubes up to the mark and were subsequently removed for counting, and the actual numbers of eggs counted were compared to expected numbers. To further validate this correlation, volumes of eggs corresponding to those measured above for 3,000 and 18,000 eggs (Table 2)  numbers. Validation by each method of 3,000 and 18,000 eggs of each species was repeated at least 3 times.

Effect of brushing on egg hatch rate
To determine if the brushing protocol affected egg survival, the hatch rate of approximately 500 eggs were placed in hatching solution without being removed from the egg paper (control) and the hatch rate of~500 eggs removed from egg paper by brushing were compared.

Statistical analysis
For the relationship between number of eggs, weight and volume, Pearson's Correlation coefficients were calculated and tested using Minitab 13.32 (Minitab Inc., Pennsylvania). Ae. aegypti and Ae. albopictus egg batch weight and volume were compared using SPSS 19.0 statistical software (IBM SPSS Statistics, New York) to calculate two sample t tests for independent samples. For validation, a t test was conducted to compare the expected mean with the observed number.
Hatch rates were arcsin transformed (√hatch rate) to allow comparison by t test and analyzed for an effect of brushing.

Relationship between weight and quantity of eggs
Egg number and weight followed a significant linear relationship in both Ae. aegypti and Ae. albopictus (y = 0.0087× − 0.0912 with r = 0.99, S = 2.547, P < 0.0001 and y = 0.007× + 1.0317 with r = 0.99, S = 2.090, P < 0.0001, respectively) ( Figure 1). The weight of Ae. aegypti eggs was shown to be significantly greater than that of Ae. albopictus eggs (Table 1).
The size of Aedes aegypti eggs was shown to be significantly greater than those of Aedes albopictus eggs ( Table 2).

Validation of the relationship between egg number and weight
Quantities of Ae. aegypti and Ae. albopictus eggs expected from the weight experiment above to contain 3,000 (25.9 mg and 22.1 mg, respectively) and 18,000 (159.8 mg and 131.5 mg, respectively) eggs were weighed out and then counted, and the data are presented in Table 3. No significant difference was observed between the expected number of eggs and observed number of eggs, confirming the weighing of dry eggs to be a reliable method for quantifying eggs.

Validation of the relationship between egg number and volume
Volumes of Ae. aegypti and Ae. albopictus eggs expected from the volume experiment above to contain 3,000 (50.7 μl and 45.2 μl, respectively) and 18,000 (277.4 μl and 230.3 μ respectively) eggs were measured out and then counted, and the data are presented in Table 4. No significant difference was observed between the expected number of eggs and observed number of eggs except for the volume estimated to be 3,000 eggs for Ae albopictus, where significantly more eggs than expected were counted from the measured volume.

Discussion
A convenient and accurate approach to quantify the dried eggs of Ae. aegypti and Ae. albopictus has been developed, allowing for standardized larval rearing of Aedes mosquitoes. A highly significant correlation between egg number and both weight and volume was observed, and the low variability between replicates indicates a good reproducibility. Considering the management required to produce and coordinate the large quantities of eggs needed in a mass rearing setting, the techniques developed here appear to be more practical on a very large scale than the method previously employed [17] using digital image analysis to estimate Aedes egg numbers present on egg papers. The behavior of Ae. aegypti and Ae. albopictus reared in the mass rearing cages and developmental trays developed by Balestrino et al. [10,18] allow egg production by a colony to be predicted with some accuracy. Indeed the capacity of Aedes species to firmly oviposit onto a removable substrate (the oviposition paper) [19,20] and the resistance of eggs to drying [21,22] simplifies the collection and maturation process. For example, a mass rearing cage containing 13,000 adult Ae. albopictus allows the harvesting of an egg paper with around 100,000 eggs following one blood meal [10]. Egg papers can then be dried and stored in laboratory conditions. When needed, and because of the robust nature of the eggs, they can be brushed and handled without significant decrease in hatch rate after a storage duration of several weeks (8 to 10 weeks as for Ae. aegypti [23,24]) and the quantity estimated.
However, standardized tools need to be developed. In the mass rearing trays (100 × 60 × 3 cm with a capacity of 6 L of water), the optimal quantity of larvae reared in each tray is about 12,000 to 18,000 [7]. Since after drying, storage and brushing, hatching rate of Ae. aegypti (Juazeiro strain) and Ae. albopictus (Rimini strain) is about 90%, between 13,333 and 20,000 eggs per tray would be needed. Several options could be used to measure and deposit eggs into trays: for example, a measuring spoon sized to contain the desired quantity of eggs could be used to collect and transfer the eggs to trays, or appropriately sized pharmaceutical capsules dissolvable in water could be used to hold and deposit the eggs. Further experiments will deal with the use of hypromellose capsules (Qualicaps® Europe, Spain) of different sizes (No. 4,5,6) to obtain the number of eggs suitable for the mass rearing trays.
Although the relationship between quantity and weight or volume of the eggs of two Aedes species has been defined here, the application of either of these accurate quantification methods for eggs should be based on a strict, reliable and standardized mass rearing process, since the weight and size of Aedes eggs can be affected by several aspects of mass rearing such as egg storage [25,26] as well as the adults' nutrition or level of health [27].

Conclusions
Two practical and simple methods of egg quantification were tested and validated. Weight and volume measurements have been shown to be a consistent and reliable means to quantify eggs for transfer to trays to allow uniform rearing of the immature stages of Aedes mosquitoes in a mass rearing setting.